Backup Services Commands
Page 34-2
Backup Services Commands
Backup services provides commands to view and configure your backup services. All
commands start with “bs” for “Backup Service” followed by the function desired. All backup
commands may be typed in full, or a three character abbreviation may be used (e.g. bsadd or
bsa may be used to create a backup service).
Accessing the Backup Services Menu
The Backup Services menu is a submenu to the Interface menu. To access the Interface
menu, enter inter, followed by <return>, as shown below.
/ % inter <return>
To display a command summary for the Interface menu, enter ?, followed by <return>:
/inter % ?
A screen similar to that shown below will display:
Command Networking Menu
------------ --------------------------------------------------------
slipc Configure SLIP (Serial Line IP) on a TTY Port
atm Enter the atm Management submenu
eth100 Enter the 100BaseT submenu
10/100 Enter the 10/100BaseT submenu
wan Enter the Wide Area Networking submenu
backup Enter Backup networking command submenu
Main File Summary VLAN Networking
Interface Security System Services Help
To enter the Backup menu, enter backup, followed by <return>, as shown below:
/Interface % backup <return>
To display a command summary for the Backup Services menu, enter ?, followed by <return>.
/Interface/backup % ? <return>
A screen similar to that shown below will display:
Command Networking Menu
------------ --------------------------------------------------------
bsadd Add a Backup Service
bsmodify Modify a Backup Service
bsview View Backup Service(s)
bsdelete Delete a Backup service
bsstatus Display Backup service status
bsclear Clear Backup service status
Main File Summary VLAN Networking
Interface Security System Services Help
To Next Page
Loading...
Need help?
General
