Alcatel Omni Switch/Router - Viewing Slot Data

Viewing Slot Data
Page 9-14
Viewing Slot Data
You can view slot table information by entering the slot command. To view information on a
particular slot, enter the slot command together with the slot number. For example, to view
information for slot 1, enter
slot 1
at the system prompt. You can also view information on all slots in the switch at the same
time in a table. To view data, for all slots in the switch, enter
slot
at the system prompt. A table similar to the following will be displayed.
Module-Type Adm-Status HW Board Mfg Firmware-Version
Slot Part-Number Oper-Status Rev Serial # Date Base-MAC-Address
------- ----------------------------------------------------------------------------------------------------------------------------
1* MPM Enabled L3 52601675 01/05/01 4.305002600 Operational
00:20:da:04:21:f0
2 HSM Enabled B11 53404264 01/19/01 4.3 05003106 Operational
00:20:da:02:28:60
2-1 FDDI D 53404104 01/24/01 05003706
3 HSM Enabled Enabled L 53404645 01/21/01 4.3 05003106 Operational
00:20:da:04:87:30
3-1 ATM B 53404116 01/11/01 05004400
4 Ether/8 Enabled D 53404229 01/07/01 4.3 05000014 Operational
00:20:da:03:09:90
5 F-Ether/M Enabled A5 73250839 01/07/01 4.3 05015906 Operational
00:20:da:85:40:50
The fields display by the slot command are described below.
Slot. The slot number for the MPX or switching module.
Module-Type. The type of module in this slot.
Part-Number. The factory-assigned part number.
Adm-Status. The administration status. This can be enabled or disabled by the operator
through the
reset command, which is described in Chapter 36, “Running Hardware Diagnos-
tics.”
Oper-Status. The operational status. Whether the port is Up (Operational), Down, or
Unknown. (Unknown means uninitialized or that the module is in a transitional state.)
HW Rev. The revision number for this module. This number may be helpful when trouble-
shooting.
Board Serial #. Serial number for this module.
Mfg Date. The manufacturing date for this module.
Firmware-Version. The version of the module’s firmware. All modules should use the same
version of software.
Base-MAC-Address. The base MAC address(es) of this module.