Loading a File From the Primary MPX
Page 6-17
Loading a File From the Primary MPX
The mpmget command loads a file from the primary MPX and copies it into the secondary
MPX. This command is only available and can only be run from a secondary MPX. To use this
command, enter mpmget, followed by a space, a slash (/), the name of the flash directory,
another slash (/), and the name of the file you want to transfer.
For example, to load the file
mpm.log from the /flash directory on the primary MPX to the
secondary MPX you would enter
mpmget /flash/mpm.log
at the system prompt. After a brief moment, the file will be transferred into the secondary
MPX. The following would then be displayed.
Transferring .. Complete
To Next Page
Loading...
