Deleting a Group
Page 19-43
Deleting a Group
You can delete a Group as long as it does not contain any virtual ports. The default Group,
Group #1, cannot be deleted. To delete a Group, enter rmgp followed by the Group number
you want to delete. For example, if you wanted to delete Group 5, you would enter:
rmgp 5
If the Group does not contain any virtual ports, then a confirmation message displays:
GROUP 5 removed.
If the Group still contains virtual ports, then a message similar to the following displays:
GROUP 5 has active entries, you must remove
these prior to removing the GROUP (use rmvp for this).
You must first remove the Group’s virtual ports before the Group can be removed. The rmvp
command allows you to remove virtual ports. See Deleting a Virtual Port on page 19-46 for
information on using this command.
♦ Note ♦
Some commands in the Bridge Management menu
(described in Chapter 17, “Configuring Bridging Param-
eters”) require you to select a Group before making
configuration changes. If you delete the currently
selected Group with
rmgp, then the new currently
selected Group reverts to the default Group, Group #1.
To Next Page
Loading...
Need help?
General
