Clearing System Statistics
Page 9-16
Clearing System Statistics
You may want to clear statistics for a specific module, port or service for dialogistic or
accounting purposes. To clear switch statistics enter
clearstat
at the system prompt. A screen similar to the following will display.
Usage: clearstat slot [,port] [,service] [,instance]
As indicated in the prompt, you can clear all statistics from a module by entering the slot
number as shown here:
clearstat 3
This entry will clear all statistics for the module located in slot 3. If you want to clear statistics
for a specific port, service or instance, enter the clearstat command followed by the appropri-
ate numbers. You must use a comma (,) to separate the slot number from the port, service
and instance numbers. The following command will clear all statistics for port 1 of the
module located in slot 3.
clearstat 3,1
♦ Caution♦
When the
clearstat command is used, no notification is
sent to the SNMP manager about the cleared statistics.
Use of this command can cause unpredictable results
with your NMS statistics.
To Next Page
Loading...
