Alcatel Omni Switch/Router - Resetting a Secondary MPX

Resetting a Secondary MPX
Page 6-19
Resetting a Secondary MPX
The secreset command initiates a soft reset on the secondary MPX. Conceptually, resetting a
secondary MPX with this command is similar to switching off power to the module; the MPX
will be in the same state after a reset as it is after a power on.
To reset a secondary
MPX, enter
secreset
at the system prompt. Messages similar to the following will display:
Module 1 changed while Swap OFF
Syncing configuration data with secondary 1 .. complete
♦ Note ♦
To reset a switching module, use the
reset command,
which is described in Chapter 36, “Running Hardware
Diagnostics.”