Viewing T1 Remote Statistics
Page 33-22
Clearing the Framer Statistics for a T1/E1 Port
The tecls command enables you to clear the accumulated physical-layer (Framer) statistics for
a T1 or E1 port. To clear statistics, enter
tecls <slot>/<port>
where <slot> is the slot number where the board is located, and <port> is the port number on
the board on which you want to clear statistics. For example, to statistics for Port 2 on the
board in slot 5, enter
tecls 5/2
Once the statistics have been cleared, the following message will be displayed:
Statistics of port 5/2 have been cleared.
To Next Page
Loading...
