UI to CLI Command Cross Reference
Page 4-4
UI to CLI Command Cross Reference
The chapters in this Users Guide are organized around the UI commands as they are grouped
into menus and sub-menus. Even though the Omni Switch/Router software has been changed
to boot up in the CLI mode, the Users Guide conforms to its original design. The CLI
commands are fully documented in the Text-Based Configuration CLI Reference Guide.
This section presents the key
UI commands that are explained in this User’s Manual along
with their CLI equivalents. Where the CLI commands support partition management, these
tables also list the partition management family to which the commands belong.
Hardware Commands
The hardware section of this manual set consists of Chapters 1 through 3. There are relatively
few UI commands in this section because these chapters cover the hardware elements of the
switch. The commands defined in these chapters are listed in the Hardware Table beginning
on page 4-4.
Basic Switch Management Commands
The table beginning on page 4-5 summarizes the features supported in the UI and the CLI for
Chapters 4 through 11.
Hardware Table
Chapter
UI Command
Equivalent CLI Commands PM Family
1, “OSR
Chassis/Power
Supplies”
No UI commands are defined in
this chapter.
N/A N/A
2, “MPX” ethernetc ethernet management port
view ethernet manage port
GF-interface
3, “OSR
Switching
Modules
10/100cfg
10/100vc
ethernet
view interface fastethernet
GF-interface
To Next Page
Loading...
Need help?
General
