Alcatel Omni Switch/Router - Serial Port Example

The WAN Port Software Menu
Page 28-15
Serial Port Example
In this example, port 1 on slot 3 is a serial port, using Frame-Relay. To modify serial port 3/1,
enter:
wpm 3/1
A screen similar to following displays:
1) Admin Status ................................................................................. UP
{(U)p, (D)own}
2) Speed in BPS ................................................................................. 2048000
{9600, 19200, 56000, 64000, 128000, 256000, 512000, 768000}
{1024000, 1544000, 2048000}
3) Clocking ........................................................................................ External
{(I)nternal, (E)xternal, (S)plit}
4) Protocol Type ................................................................................ Frame Relay
{(F)rame Relay, (P)PP(Point to Point)}
7) Receive Clock ............................................................................... Normal
{(N)ormal, (I)nverted}
8) TOS for Voice Data ........................................................................ a0
TOS Value in Hex for Voice Data, 0 to disable TOS
9) TOS for Voice Signaling Data ......................................................... 60
TOS Value in Hex for Voice Signaling Data, 0 to disable TOS
10)TOS Mask for both TOS Value .........................................................e0
TOS Mask in Hex for Type of Data
11) Signaling IP Address ..................................................................... 0.0.0.0
IP Address range
12) Signaling IP Mask .......................................................................... 255.255.255.255
IP Mask range
15) Loopback Timeout .........................................................................10
{Timeout (0..255)}