Bridging Commands
Page 17-13
Displaying Static Bridge Addresses
You can view static bridge address information by entering the fs command. To display the
information, enter the fs command as follows:
fs <group number>
where <group number> is the number of the group for which you want to view static bridge
MAC addresses. For example, to view MAC addresses for Group 1, you would enter the
following:
fs 1
This command will display a table similar to the following:
Bridge Static Address Summary for Group 1 (Default GROUP (#1))
MAC Address Slot/Intf/Service/Inst Static Status
--------------------------- ------------------------------ -------------------
002A3113:0012EA 3/ 1/ Brg/ 1 permanent
As a variation of this command, you can enter the fs command at the system prompt with no
group number. This will allow you to view the static bridge addresses on the currently
selected group. For information on selecting a group, see Selecting a Default Group on page
17-7.
The descriptions for the variables in the table displayed with the
fs command are the same as
those in the table displayed with the fc command. For details on these variables, see Config-
uring a Static Bridge Address on page 17-10.
To Next Page
Loading...
Need help?
General
