Configuring IPX RIP/SAP Filtering
Page 27-22
Deleting an IPX RIP/SAP Filter
Follow the steps below to delete an existing IPX RIP or SAP filter.
1. Enter
ipxfilter.
A screen similar to the following displays:
Selecting global IPX filter:
Add or delete entry {add(a), delete(d)} (a) :
Enter d to select to delete a filter.
2. A screen similar to the following displays:
Displaying all filters:
GP:VL (s/p/vc)
# Type Net/Mask Node/Mask Svc Md (Peer ID)
------ ------------ ---------------------- ----------------------------------- ------ ---- --------------------
1 SAP OUT 67/ffffffff 000000000001/ffffffffffff ALL B global
2 SAP IN 67/ffffffff 000000000001/ffffffffffff 0278 B 1:1
3 RIP IN 67/ffffffff B global
Entry number to delete? (default: none) : 1
This screen contains a list of the existing IPX RIP/SAP filters. The fields on this screen are
described in the next section (see Displaying IPX RIP/SAP Filters on page 27-23).
3. Enter the index number of the filter you want to delete. If you decide at this point that
you want to abort out of the deletion process, simply press
<Enter> to accept the default
of “none.”
4. A message will confirm the deletion of the filter:
ipxfilter successfully deleted.
To Next Page
Loading...
