NetBIOS Relays
Page 26-15
Forwarding VLANs for NBNS Relay
At least one forwarding VLAN (or a next-hop address as described in Next-Hop Addresses for
NBNS on page 26-14) must be configured for NBNS relay.
To select forwarding
VLANs for NBNS relay:
1. On the command line of the UDP Relay Configuration screen, enter the following:
22=l
A screen similar to the following displays:
Available/Selected VLANS
Item Group ID:VLAN ID MASK IP ADDR
1) 1:1 255.255. 0. 0 172. 23. 9.105 *
* = selected for forwarding
Enter item number of VLAN to be selected [‘h’f or help/<ret> to exit] :
2. Enter the item number of the group/VLAN that you want to select. Repeat this step for all
the groups/VLANs you want to select.
3. Press
<Enter> to return to the command line for the UDP Relay Configuration screen.
4. Enter
s to save the changes.
To deselect forwarding
VLANs:
1. On the UDP Relay Configuration screen, enter
22=d
The Available/Selected VLANs screen displays.
2. Enter the item number of the group/
VLAN that you want to select. Repeat this step for all
the groups/VLANs you want to select.
3. Press
<Enter> to return to the command line for the UDP Relay Configuration screen.
4. Enter
s to save the changes.
To Next Page
Loading...
