The WAN Port Software Menu
Page 28-37
Deleting Ports
The wpdelete command allows you to delete configuration information for a WSX port. When
you delete a this information, all WAN configuration parameters for the selected port revert
back to default settings.
To delete a port configuration, enter the following command:
wpdelete slot/port
in which slot is the slot number for the WSX board and port is the port number on the WSX
board that you want to delete. For example, to delete port 1 on the WSX board in slot 2,
enter:
wpdelete 2/1
or
wpd 2/1
This system returns the following prompt to confirm the deletion:
This will delete Slot 2, Port 1. Continue? {(Y)es, (N)o} (N)
Enter a Y to confirm the deletion or press Enter to cancel the deletion.
Note
The
wpdelete command requires that you indicate a slot
and port number. For example,
wpdelete
would be an incorrect usage, whereas,
wpdelete 4/2
would be correct.
To Next Page
Loading...
Need help?
General
