Installing a Switching Module
Page 3-6
Removing a Switching Module
To remove a switching module, follow the instructions below. If you are “hot swapping” the
modules (i.e., removing and inserting while power is on), see Hot Swapping a Switching
Module on page 3-7.
♦ Anti-Static Warning ♦
Before handling a switching module, free your hands
of static by wearing a grounding strip, or by grounding
yourself properly. Static discharge can damage the
components on your switching module.
1. Loosen the screw fasteners at the top and bottom of the switching module using a stan-
dard screwdriver.
2. Gently unlock the two card ejectors by pulling them out away from the module.
3. With both hands, carefully pull the module free of the chassis enclosure.
To Next Page
Loading...
Need help?
General
