Bridging Commands
Page 17-14
Displaying Bridge Port Statistics
You can display statistics on bridge ports with the bps command. To view bridge port statis-
tics enter the bps command as follows:
bps <group number>
where <group number> is the number of the group for which you want to view bridge port
statistics. For example, to view statistics for Group 1, you would enter the following:
bps 1
This command will display a table similar to the following:
Frames discarded due to full Forwarding Database:0
Port Statistics for Group 1
MTU Delay Flood
Slot/Intf Frames Frames In Frames Exceeded Exceeded Limit
Service/Inst In Out Discards Discards Discards Discards
=========== ======== ======== ======== ======== ======== ========
2/ 1/ Brg/ 1 0 0 0 0 0 0
2/ 2/ Brg/ 1 0 0 0 0 0 0
3/ 1/ Brg/ 1 3354 85 0 0 0 0
3/ 2/ Brg/ 1 0 0 0 0 0 0
3/ 3/ Brg/ 1 0 0 0 0 0 0
3/ 4/ Brg/ 1 0 0 0 0 0 0
3/ 5/ Brg/ 1 0 0 0 0 0 0
3/ 6/ Brg/ 1 0 0 0 0 0 0
3/ 7/ Brg/ 1 0 0 0 0 0 0
3/ 8/ Brg/ 1 0 0 0 0 0 0
/VLAN/Bridge %
As a variation on this command, you can enter bps at the prompt without a group number.
This will display the port statistics for the currently selected group. For information on select-
ing a group, see Selecting a Default Group on page 17-7.
To Next Page
Loading...
