Managing User Login Accounts
Page 8-19
For example, if you wanted to assign the user account the privilege to use the define
command, enter the number 6 as shown here.
Give the family number : ( ) : 6
The following will display.
Give rights on subset DEFINE
0. NO
1. YES
( ) :
If you enter 1, all the command families will display and the DEFINE command under the
global family will be shown as follows:
- DEFINE : YES
After you set the user account privileges, the switch displays the current configuration. At this
point you may enter
s to save your configuration or c to cancel.
♦ Warning♦
If partition management is implemented on a user
account, that account must have the
UI command
family set to NO privilege. If an account has the privi-
lege to use the UI command, partition management is
effectively destroyed for that account.
Global Family Table
Number Global Family
1 System
2 Status
3 Slot
4 Timeout
5 Prompt
6 Define
7 Prefix
8 Reboot
9 Telnet
10 FTP
11 Ping
12 Swap
13 Reset
14 CD
15 LS
16 RM
17 File
18 Interface
19 Ethernet
20 Gated
21 UI
To Next Page
Loading...
