NTP Statistics Menu
Page 12-23
NTP Statistics Menu
To view the NTP Statistics Menu, enter the ntstats command at the system prompt. If you are
in verbose mode the NTP configuration menu is displayed. Otherwise, enter a question mark
(?) at the prompt to display this menu:
Command NTP Statistics Menu
--------------- --------------------------------------------------------
ntpstat display local server statistics
ntppstat display server statistics associated with particular peer(s)
ntploopinfo display loop filter information
ntpmem display peer memory usage statistics
ntpio display I/O subsystem statistics
ntptimer display event timer subsystem statistics
ntpreset reset various subsystem statistics counters
ntppreset reset stat counters associated with particular peer(s)
ntpctlstat display packet count statistics from the control module
ntpleap display the current leap second state
ntpmon turn the server's monitoring facility on or off
ntpmlist display data the server's monitor routines have collected
Related Menus:
Ntconfig Ntinfo Ntstats Ntadmin Ntaccess
The main menu options are shown in the Related Menus list for quick access if you need to
change menus.
Display Local Server Statistics
The ntpstat command allow you to view statistics for the local NTP entity (switch). To view
statistics, enter the ntpstat command at the system prompt. A display similar to the following
is displayed:
system uptime: 0
time since reset: 0
bad stratum in packet: 0
old version packets: 0
new version packets: 16
unknown version number: 0
bad packet length: 0
packets processed: 0
bad authentication: 0
limitation rejects: 0
To Next Page
Loading...
Need help?
General
