Generic Service UDP Relay
Page 26-22
4. Enter d to return to the UDP Relay Configuration screen.
5. Enter
s to save the changes and reinitialize the relay.
Deleting a Generic Service
To delete a generic service:
1. On the Generic Services Menu, enter
42. The Configured Generic Services screen displays
similar to the following:
Configured Generic Services
Item State Port Number Description Servers/Vlans
(1) enabled 80 TFTP 198.172. 5. 4
Enter item number of service to be deleted [‘h’ for help/<ret> to exit] :
The parameters are defined in Modifying a Generic Service on page 26-21.
2. Enter the item number of the service you want to delete. A message similar to the follow-
ing displays:
Are you sure you want to delete item 1? [y/n] (n) :
3. Enter y to delete the service. The Configured Generic Services screen redisplays with the
State parameter changed to deleted. At this point, the service is marked for deletion but
has not actually been deleted from the configuration.
Configured Generic Services
Item State Port Number Description Servers/Vlans
(1) deleted 80 TFTP 198.172. 5. 4
Enter item number of service to be deleted [‘h’ for help/<ret> to exit] :
4. Select any other services to be marked for deletion. Press <Enter> to return to the Generic
Services Menu.
5. Enter
q to return to the UDP Relay Configuration screen.
6. Enter
s to save the changes and delete the selected service(s).
To Next Page
Loading...
