Alcatel Omni Switch/Router - Displaying Current Router Interface Status

Displaying Current Router Interface Status
Page 9-4
Displaying Current Router Interface Status
To display current interface status information, enter
si
at the system prompt. A screen similar to the following will be displayed.
Interface Summary Status
4 Interfaces
Logical Interface Administrative Operational
Interface Type Status Status
-------------- ---------------------------- ----------------------- ---------------------
1 Slip Enabled Enabled
2 Virtual Router Enabled Active
3 Virtual Router Enabled Active
4 SoftwareLoopback Enabled Enabled
The fields displayed by the si command are described below.
Logical Interface. A number, in sequence, that has been assigned to the virtual router port.
Interface Type. The type of interface, which can be virtual router (the standard interface type),
SLIP, and software loopback.
Administrative Status. Whether the administrator has enabled or disabled the port. The port can
be enabled by the administrator but still be made inactive by the system.
Operational Status. Whether the port is active (operational) or inactive. This status is set by the
system software.