Modifying an AutoTracker VLAN
Page 22-26
Changing the Admin Status for a VLAN Policy
1. At the
Option= prompt enter a 5 and press <Enter>.
2. The following menu displays:
Enter rule number:
The rule number is listed with other information on the VLAN just after you entered the
modatvl command. Find the number corresponding to the rule you want to change and
enter it at this prompt and press <Enter>.
3. The following menu displays:
Set Rule Admin Status to ((e)nable/(d)isable):
Type an E to enable this rule or a D to disable it. If the rule is enabled, the VLAN will start
using the rule criteria to segment data traffic.
The system returns to the
Available Options menu. You can modify more attributes for this
VLAN, or quit modifying the VLAN by typing a 6.
Deleting an AutoTracker VLAN
You can delete an AutoTracker VLAN. When you delete a VLAN, traffic is no longer filtered
according to the VLAN’s policies. Follow these steps to delete a VLAN.
1. Enter
rmatvl followed by the Group number, a colon (:), and the VLAN number that you
want to delete. For example to delete VLAN 2 in Group 3, you would enter:
rmmcvl 3:2
2. The following prompt displays:
Delete VLAN 3:2 ? (n):
Enter a Y and press <Enter> to complete the deletion of the VLAN. A message display
confirming the deletion.
VLAN 3:2 deleted
To Next Page
Loading...
Need help?
General
