Port Mapping
Page 19-70
Adding Ports to a Port Mapping Set
You can add ports to a port map set once it has been created using the pmapmod command.
Follow these steps:
1. Enter the
pmapmod command at a system prompt, as shown:
pmapmod <pmap id>
where <pmap id> is the map set number shown when the map set was created. (To view a
list of all existing map sets, see Viewing a Port Mapping Set on page 19-72.) For example,
to modify map set 5, you would enter the following:
pmapmod 5
2. The following screen displays:
Port Mapping Configuration
=======================
Port Map Id Ingress Ports Egress Ports
----------------- ------------------- ------------------
5 3/1, 3/2, 3/3 4/1, 4/2, 4/3
Modify Port Map 5
1. Add Ports to Ingress List :
2. Add Ports to Egress List :
3. Delete Ports from Ingress List :
4. Delete Ports from Egress List :
5. View Port Map Configuration :
Note that the current ports in the port mapping set are displayed. Use this information to
make decisions on the ports you want to add or remove from the set.
Enter the line number for the operation you want to perform (a
1 for the ingress list or a 2
for the egress list), an equal sign (=), and the ports to be added. For example, add port
3/2 to the ingress list and the egress list, enter the following (in two separate operations):
1=3/2
2=3/2
You can add more than one port to a list by using a comma (,) between slot/port designa-
tions, or a dash (-) between port numbers. For example, if you wanted to make ports 4/1,
4/6, 4/7, 4/8, and 4/9 egress ports for this map set, you would enter the following:
2=4/1, 4/6-9
3. To view the changes, enter a 5 (View Port Map Configuration), and equal sign (=), and a y,
as shown:
5=y
This will refresh the Port Mapping Configuration screen and display any changes you
have made.
4. Quit the session by entering a
q at the prompt.
To Next Page
Loading...
Need help?
General
