The WAN Port Software Menu
Page 28-42
Field Descriptions
The following section explains the fields and their corresponding values.
PT
The port number on the
WSX board for which statistics are displayed.
Admin/Oper Status, Int Type, Speed Bps
These columns are described in the section, Obtaining Information on All Boards in a Switch
on page 28-38. Please refer to this section for detailed information.
Frames In
The total number of frames received on this port since the last time the switch was initialized.
Frames Out
The total number of frames sent on this port since the last time the switch was initialized.
Octets In
The total number of octets, or bytes, received on this port since the last time the switch was
initialized. This statistic includes the data and Frame Relay or PPP header fields, but does not
include CRC or flag characters.
Octets Out
The total number of octets, or bytes, sent on this port since the last time the switch was
initialized. This statistic includes the data and Frame Relay or PPP header fields, but does not
include CRC or flag characters.
Viewing Information on a Single Port
To obtain status information on a single WSX port, enter the wpstatus command, followed by
the slot number for the WSX board and the port number for which you want to receive
information, as follows:
wpstatus <slot>/<port>
or
wps <slot>/<port>
where <slot> is the slot number where the WSX board is installed and <port> is the port
number on the WSX board.
To Next Page
Loading...
Need help?
General
