Obtaining Status and Statistical Information
Page 29-43
Information on One Port
To obtain status information on a single WSX port, you enter the frstatus command along with
the slot number for the WSX board and the port number for which you want to receive infor-
mation, as follows:
frstatus <slot>/<port>
where <slot> is the slot number where the WSX board is installed and <port> is the port
number on the WSX board. For example, if you wanted to obtain status information for Port 1
on the WSX module in Slot 4, you would enter:
frstatus 4/1
This command displays a screen similar to the one shown on the following page:
To Next Page
Loading...
Need help?
General
