Alcatel Omni Switch/Router User Manual

Removing an IPX Static Route
Page 27-13
Removing an IPX Static Route
The ripxsr command is used to remove IPX static routes from the switch’s IPX Routing Table.
Follow the steps below to remove an IPX static route.
1. Enter
ripxsr.
A screen similar to the following displays:
Do you want to see the current route table?
(y or n) (y) : y
2. Enter y at this prompt (or press <Enter>) to display the current routing table.
A screen similar to the following displays:
Displaying all (4) routes:
Dest Net Router Hops Delay Static Aged Redir Chg Dir GP:VL
3333 e8024.0000c021a5b8 1 3 N Y N N N 7:1
5555 5555.Direct 0 1 N N N N Y 4:1
e8024 e8024.Direct 0 1 N N N N Y 7:1
3041c204 e8024.0000c021a5b8 1 3 N Y N N N 7:1
aaaaaa 304.0020da05f694 1 1 Y N N Y N 7:1
Destination IPX network :
3. Enter the name of the destination IPX network you want to remove.
A message will confirm the deletion of the static route:
Route successfully deleted.

Alcatel Omni Switch/Router Specifications

General

Brand	Alcatel
Model	Omni Switch/Router
Category	Network Router
Language	English