Deleting a Frame Relay Service
Page 29-66
Deleting a Frame Relay Service
You can delete a Frame Relay service using the das command as follows:
1. Enter
das followed by the slot, port and service number for the Frame Relay service that
you want to delete. You can obtain the service number by using the vas command. See
Viewing Frame Relay Services on page 29-64. For example, if you wanted to delete service
number 2 for Port 2 on the WSX board in Slot 3, you would enter
das 3/2 2
and the following screen would display:
Frame-Relay Services
Service Service
Slot Port VCs Groups Number Vport Description Type
==== ==== ==== ====== ======= ===== =============== =========
3 2 16 1 1 10 Virtual port (#10) Bridging
3 2 17 1 2 14 Virtual port (#14) Bridging
Remove Frame Relay Slot 3 Port 2 Service 2 (n)? :
2. Enter 1 and press <Enter> to confirm the deletion of this service. The following messages
display confirming the deletion of the service:
Removing Frame Relay Slot 3 Port 2 Service 2, please wait...
Frame Relay Slot 3 Port 2 Service 2 removed
To Next Page
Loading...
Need help?
General
