Alcatel Omni Switch/Router - Viewing Parameters for All Ports in a Single Submodule

The WAN Port Software Menu
Page 28-28
Viewing Parameters for all Ports in a Single Submodule
To view port parameters for all ports on a particular submodule, enter the wpview command,
followed by the number of the slot. In the following three examples, the port parameters are
displayed for an ISDN-BRI board, a serial board, and a T1 board.
ISDN-BRI Board Example
To display the parameters for all ports on the ISDN-BRI board (in slot 3), enter:
wpview 3
or
wpv 3
A screen similar to following displays:
Admin/
Oper/ Speed
Port PortType Intf. Type State Protocol BPS Clocking
==== ====== ========== ====== ======== ======= ========
1 ISDN ISDN-ST UP/UP PPP N/A N/A
Serial Board Example
To display the parameters for all ports on the serial board (in slot 3), enter:
wpview 3
or
wpv 3
A screen similar to following displays:
Admin/
Oper/ Speed
Port PortType Intf. Type State Protocol BPS Clocking
==== ====== ======== ====== ======== ======= ========
1 Serial V35DCE UP/UP PPP 2048000 Split
T1 Board Example
To display the parameters for all ports on the T1 board (in slot 3), enter:
wpview 3
A screen similar to following displays:
Admin/
Oper/ Speed
Slot/Port PortType Intf. Type State Protocol BPS Clocking
======== ======= ========== ====== ======== ======= =======
3/1 T1 T1 UP/UP FR 1544000 Loop
♦ Note ♦
E1 boards provide a similar display, except the port
type and interface type display as
E1 and speed
displays as 2048000.