Detecting Problems
Page 35-2
This chapter lists UI error messages. Refer to the appropriate hardware chapters for a
complete description of LED states. Refer to NMS online documentation for explanations of
NMS error messages. Refer to Chapter 25, “IP Routing,” for procedures to use the ping
command. Refer to Chapter 36, “Running Hardware Diagnostics,” for documentation on diag-
nostics software. And refer to the Text-Based Configuration CLI Reference Guide for documen-
tation on CLI commands.
Software problems can be detected through:
•
LEDs (OK2)
•
NMS error reporting
• CLI diagnostic commands (e.g.,
dump and configuration check)
•
UI error messages
This chapter lists
UI error messages. Refer to NMS online documentation for explanations of
NMS error messages. And refer to the Text-Based Configuration CLI Reference Guide for docu-
mentation on CLI commands.
To Next Page
Loading...
Need help?
General
