Running Hardware Diagnostics
Page 36-13
The module is reset, and then the rest of the tests will run.
Testing Slot 3 - Ether/12
Resetting slot 3...
Test In Progress: CSR Test
OK1, OK2 LEDS will display the following pattern: OFF RED OFF GREEN OFF
AMBER OFF - Passed
Test In Progress: VRAM Test - Passed
Test In Progress: CAMOFFBRD Test(1K) - Passed
Loading dni.img...
Test In Progress: BOARDUP Test - Passed
Test In Progress: CAMONBRD Test(1K) - Passed
Test In Progress: VBUS Test - Passed
Restoring slot 3...
Test In Progress: PORT Test (3-0)
Wait for ports to come up . Done.
Error - Frame #1 not found - Failed
FAILED - PORT TEST: Tx Port1 -> Rx Port2 at Test Number 95001
Expected Data: 1
Measured Data: 0
Test Summation:
Started: WED DEC 17 10:48:13 2000
Slot 3 Passes Fails
Ether/12 (3-0)
CSR 1 0
VRAM 1 0
CAMOFFBRD 1 0
BOARDUP 1 0
CAMONBRD 1 0
VBUS 1 0
PORT 0 1
Failure Summation:
Ether/12 (3-0)
Test Fail No. Test No. Exp. Data Meas. Data Iter. No. Time Temp (C)
PORT 1 95001 00000001 00000000 1 10:49:47 30.5
Completed: WED DEC 17 10:49:47 2000
Disconnect the following cables on Slot 3:
Port 1 to Port 2
Port 3 to Port 4
Port 5 to Port 6
Port 7 to Port 8
Port 9 to Port 10
Port 11 to Port 12
Press <Enter> when finished.
To Next Page
Loading...
