Alcatel Omni Switch/Router - Page 1066

Boot Prompt Basics
Page A-4
Displaying Current Configuration (p)
To display the current configuration, enter a p at the Boot prompt. A screen similar to the
following will be displayed.
Boot device : ffs
Boot file : /flash/mpx.img
Eth IP addr[:mask] : 192.168.11.1
Startup script : /flash/mpx.cmd
Console params : 9600,n81c
Modem params : 9600,n81
Boot flags : 0xb
Other : dvip:no-name,192.168.10.1,255.255.255.0,192.168.10.255;
For information on modifying these screens, see Configuring a Switch with an MPX on page
A-7.
To change the configuration of the boot parameters, enter
c at the prompt. For more informa-
tion, see Configuring a Switch with an MPX on page A-7.
Loading the Last Configured Boot File (l)
To load the last configured boot file, enter the l command. A screen similar to the following is
shown:
Boot device : ffs
Boot file : /flash/mpx.img
Eth IP addr[:mask] : 172.22.2.20
Startup script : /flash/mpx.cmd
Console params : 9600,n81c
Modem params : 9600,n81d
Boot flags : 0xb
Other : dvip:TECHPUB-
120,172.22.2.120,255.255.0.0,172.22.255.255;
Loading /flash/mpx.img...25320 + 2163504 + 314792
entry = 0x40e00000