NTP Configuration Menu
Page 12-10
2. Adjust the configurable variables for this NTP client as needed by entering the line
number, and equal sign, and a new value at the system prompt, as shown:
<lineNumber>=<value>
For example, to change the Response timeout to 10, you would enter 1 (the line number
for Response timeout), an equal sign (=), and the number 10 (the new value), as shown:
1=10
3. Enable authentication by entering a 3, and equal sign (=), and a key file name at the
prompt, as shown:
3=ntp.keys
The NTP Startup Configuration menu expands to display new options. The menu now
appears similar to the following:
NTP Startup Configuration
1) Response timeout : 0
2) Authentication delay : No
3) Authentication key file name : ntp.keys
31) Configuration info authentication key :
32) Control request authentication key :
33) Configuration change authentication key :
4) NTP client mode : Ucast
5) Enable monitor : No
6) Enable NTP server : No
4. Adjust the configurable variables for authentication as needed by entering the line
number, and equal sign, and a new value at the system prompt, as shown:
<lineNumber>=<value>
For example, to change the Configuration info authentication key to 10, you would enter 1
(the line number for Configuration info authentication key), an equal sign (=), and the
number 10 (the new value), as shown:
1=10
To Next Page
Loading...
