Configuring the DNS Resolver
Page 14-2
To enable the resolver function, enter 1=y. A screen similar to the following then displays:
DNS Resolver Configuration
1) Resolver Enabled : Yes
2) Domain : UNSET
3) Server Address 1 : UNSET
4) Server Address 2 : UNSET
5) Server Address 3 : UNSET
Command {Item=Value/?/Help/Quit/Redraw/Save} (Redraw) :
The prompts allow you to enter a Domain Name and up to three Domain Name Servers
(identified by their IP addresses).
• To change a value, enter the number corresponding to that value, an (=), then the new
value. For example, to set a Domain Name to Company.Com, enter
2=Company.Com.
• To clear an entry, specify the value as (.) as in 2=.
• To save all your modifications, enter
save
• To cancel all your modifications, enter
quit
• To view the parameters currently configured, enter ?
To Next Page
Loading...
