Creating a New Group
Page 19-26
q. The following prompt displays:
Enter a priority level (0...7)(0):
Prioritizing VLANs allows to you set a value for traffic based on the destination VLAN of
packets. Traffic with the higher priority destination will be delivered first. VLAN priority
can be set from 0 to 7, with 7 being the level with the most priority.
Modifying and displaying a group’s priority is described in Priority VLANs on page 19-73.
You have now completed the configuration of the virtual router port for this group. At
this point, you will be asked whether you want to enable group mobility. The following
prompt will display:
Enable Group Mobility on the Group ? [y/n] (n):
Mobile groups are discussed in detail in Mobile Groups on page 19-5. If you want to
enable group mobility answer Y to this prompt, press <enter>, and go on to Step 3. Set Up
Group Mobility and User Authentication on page 19-27.
If you do not want to configure group mobility answer
N at the prompt, press <enter>,
and go on to Step 4. Configuring Virtual Ports on page 19-28 for further instructions.
To Next Page
Loading...
Need help?
General
