Rockwell Automation Publication 6000-TD004D-EN-P - November 2017 163
Parameter Descriptions Chapter 2
Power Loss Auto Restart Parameters
Cell Bypass Parameters
No. Name Min. Max. Default Values Units Modify
Root
Access
2300V 2400V 3000V 3300V 4000V 4160V 6000V 6300V 6600V 6900V 10000V 11000V U S R
P073Input Voltage Loss Filter Time 0 1000000000000000msOn/Off Y
P263Power Loss Restart Enable 0 1000000000000 OfflineYY
P264Power Loss Allowable Time 0 3600606060606060606060606060s OfflineYY
P265 Power Loss Time Max Limit 0 3600 300 300 300 300 300 300 300 300 300 300 300 300 s Offline Y
No. Name Min. Max. Default Values Units Modify
Root
Access
2300V 2400V 3000V 3300V 4000V 4160V 6000V 6300V 6600V 6900V 10000V 11000V U S R
P041Power Cell Bypass Enable 0 1000000000000 OfflineYY
P042 Power Cell Bypass Delay After Power Cell
Bypassed
20 16000 500 500 500 500 500 500 500 500 500 500 500 500 ms On/Off Y
P043 Power Cell Bypass Upper Limit For
Bypassed Feedback Time
30 500 100 100 100 100 100 100 100 100 100 100 100 100 ms On/Off Y
P044 Power Cell Bypass Fault Simulation
Power Cell Count
0 3000000000000 On/OffYY
P057 Power Cell Bypass Upper Limit Time For
Over Temperature
0 32767 10 10 10 10 10 10 10 10 10 10 10 10 s On/Off Y
P058 Power Cell Bypass Phase A Cell Number
For Simulation
0 9000000000000 On/OffYY
P059 Power Cell Bypass Phase B Cell Number
For Simulation
0 18000000000000 On/OffYY
P060 Power Cell Bypass Phase C Cell Number
For Simulation
0 27000000000000 On/OffYY
P061Power Cell Bypass Fault Simulation-3276832767000000000000 On/OffYY
P065 Power Cell Bypass Enable Frequency
Range Lower limit
0.00 19.99 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 On/Off Y
P066 Power Cell Bypass Restart Enable After
Power Cell Bypassed
0 1111111111111 Offline Y
P068One Phase Lost Filter Time 5 100030303030303030303030303010 msOn/OffYY
P078 Power Cell Reactivation Time Upper Limit 0 200 100 100 100 100 100 100 100 100 100 100 100 100 ms On/Off Y
To Next Page
Loading...
