Rockwell Automation Publication 6000-TD004D-EN-P - November 2017 43
Chapter 2
Parameter Descriptions
PowerFlex 6000 Medium
Voltage AC Drive
Database Revision # 6.xxx
This document provides detailed description of the parameters used in drive
control. The parameters are arranged into functional groups. Each description
begins with the full name of the parameter. The linear number of the parameter is
given followed by the default value, then the minimum and maximum values
showing the position of the decimal point and the units if applicable. Next is the
generic value that is assigned when a parameter initialization is performed. The
access level at which the parameter can be first seen is given. The access levels are
User, Setup, and R&D. If the parameter is first seen at a certain level and it is a
Read/Write type, it can be modified at the same or a higher level. Read only
parameters are operational variables that change with different operating
conditions. Finally, there is a short functional description of the parameter.
Please read the following information on overall parameter configuration.
To Next Page
Loading...
