Allen-Bradley PowerFlex 6000 Firmware, Parameters, And Troubleshooting Manual

Rockwell Automation Publication 6000-TD004D-EN-P - November 2017 97
Parameter Descriptions Chapter 2
Flux Control Signal Filter Time
Linear Number: P268
Default Value: 999.97 ms
Minimum Value: 0.00 ms
Maximum Value: 13663.80 ms
Access Level: R&D
Read/Write: Read/Write
Modify Level: Online/Offline
This parameter sets the Flux Control Signal Filter Time.
System Derating Control Signal Filter Time
Linear Number: P269
Default Value: 999.97 ms
Minimum Value: 0.00 ms
Maximum Value: 13499.96 ms
Access Level: R&D
Read/Write: Read/Write
Modify Level: Online/Offline
This parameter sets the System Derating Control Signal Filter Time.
Flux Control Compensation Gain
Linear Number: P272
Default Value: 25%
Minimum Value: 0%
Maximum Value: 100%
Access Level: R&D
Read/Write: Read/Write
Modify Level: Online/Offline
This parameter sets the Flux Control Compensation Gain. Assume “Verr” is the
difference between the set output voltage and actual output voltage. When the
flux control function is trigged, the deceleration time will be extended if this
parameter is less than “Verr”.
Flux Control Regulation Control Enable
Linear Number: P273
Default Value: 1
Minimum Value: 0
Maximum Value: 1
Access Level: R&D
Read/Write: Read/Write
Modify Level: Online/Offline
This parameter is used to enable or disable the Flux Control Regulation Control
function.
Value Description
0 Disable Flux Control Regulation Control
1 Enable Flux Control Regulation Control

Allen-Bradley PowerFlex 6000 Specifications

General

Brand	Allen-Bradley
Model	PowerFlex 6000
Category	DC Drives
Language	English