B13 BETTER (B13 BEST APPEARANCE) WASHING MACHINE SERVICE HANDBOOK
13
5. PRODUCT INSTALLATION / INSTALLATION RULES / SETTINGS
Refer to the nearest Authorised Service Agent for installation of the product. To make the product
ready for use, review the information in the user manual and make sure that the electricity, tap
water supply and water drainage systems are appropriate before calling the Authorized Service
Agent. If they are not, call a qualified technician and plumber to have any necessary arrangements
carried out.
Preparation of the location and electrical, tap water and waste water installations at the place of
installation is under customer’s responsibility.
Installation and electrical connections of the product must be carried out by the Authorized Service
Agent. Manufacturer shall not be held liable for damages that may arise from procedures carried
out by unauthorized persons.
WARNING:
Prior to installation, visually check if the product has any defects on it. If so, do not
have it installed. Damaged products cause risks for your safety.
Make sure that the water inlet and discharge hoses as well as the power cable are not folded,
pinched or crushed while pushing the product into its place after installation or cleaning
procedures.
5.1. Appropriate Place for Installation
Place the product on a hard and level floor. Do not put it onto a carpet with high pile or other
similar surfaces.
On a graduated floor, do not place the product next to the edge or on a platform.
Total weight of the washing machine and the dryer -with full load- when they are placed on top
of each other reaches to approx. 180 kilograms. Place the product on a solid and flat floor that
has sufficient load carrying capacity!
Do not place the product on the power cable.
Do not install the product at places where temperature may fall below 0ºC.
Place the product at least 1 cm away from the edges of other furniture.
5.2. Removing Packaging Reinforcement
Figure 5.1
Tilt the machine backwards to
remove the packaging
reinforcement. Remove the
packaging reinforcement by
pulling the ribbon.
To Next Page
Loading...
