arcelik Beko B13 - Failure; Error Codes

B13 BETTER (B13 BEST APPEARANCE) WASHING MACHINE SERVICE HANDBOOK
97
11. FAILURE / ERROR CODES
SERVICE
MODE
ERROR
CODE
DEFINITION OF ERROR
E01
NTC short circuit
NTC open circuit error
E02
Heater open circuit error
E03
Heater continuously active error
E04
Valve triac short circuit
Valve triac diode error
E05
Pump triac open circuit or Pump blocked or Pump triac diode mode or
Pump rotor locked and does not rotate error
E06
Motor triac short circuit or (UMDC)
Motor triac diode mode error (UMDC)
E07
Water level sensor reading error
E08
No water or
Valve triac open circuit or
Pump triac short circuit error
E09
Door lock triac open circuit error
E10
Door lock triac short circuit error
E11
Motor phase open circuit error (ASKOLL)
Motor triac open circuit or (UMDC)
Motor tacho open circuit (UMDC)
E12
Water level aquastop level error
E13
BLAC motor communication cable open circuit error
E15
Flowmeter open or short circuit error
E17
Foam caused the programme to end without spinning (Not error, but a
warning)
E18
Unbalanced load caused the programme to end without spinning (Not
error, but a warning)
E28
Door locked signal (zero cross) is not received error
E29
Operation voltage is out of limit error