B13 BETTER (B13 BEST APPEARANCE) WASHING MACHINE SERVICE HANDBOOK
8
3.5. Package information
Packaging materials of the product are manufactured from recyclable materials in accordance with
our National Environment Regulations.
Do not dispose of the packaging materials together with the domestic or other wastes. Take them
to the packaging material collection points designated by the local authorities.
3.6. Disposing of waste product
This product has been manufactured with high quality parts and materials which can be reused
and are suitable for recycling.
Therefore, do not dispose the product with normal domestic waste at the end of its service life.
Take it to a collection point for the recycling of electrical and electronic equipment. Please consult
your local authorities to learn the nearest collection point. Help protect the environment and natural
resources by recycling used products. For children's safety, cut the power cable and break the
locking mechanism of the loading door so that it will be non-functional before disposing of the
product.
3.7. Points to be considered during service
Make sure that the cables to be attached to the electronic card during panel installation are not
pinned with the bracket plates. Make sure that all sockets on the electronic card are seated
well.
During cable assembly installation check that if the cable is damaged or not. Stripped or
damaged cables should not be installed.
Attention should be paid to cable routing during installation; cable should not contact with or
pinned by sharp edges.
Care should be paid that all sockets of serviced components are seated well. Arcing may
occur in case of loose touch.
Check that the serviced product is connected to a grounded socket protected by a fuse with
proper current value. Do not make connections via extension cables or multi-plugs. Also, do not
extend the supply cable and inner cables.
Do not put it onto a carpet with high pile or other similar surfaces. Electrical parts may get
overheated since air cannot circulate from under the device.
Do not put the serviced product on the supply cable or any cable.
If the serviced product has to be unplugged, never pull it by the cable, always disconnect it
by pulling the plug.
Check the supply cable and plug of the serviced product. If the supply cable or plug is
damaged, replace the entire supply cable assembly by a new one. Pay special care that the cable
is not shortened, broken, peeled, hardened and the plug tips are not broken, cracked, oxidized or
loose.
Check the socket which the serviced product is plugged in. Do not make connections to
loose, displaced, broken, in contact with water, dusty, dirty and oiled sockets.
Pay attention that the supply cable is not placed under any object such as heat source,
cabinet, equipment, etc. that may damage the cable along its route from the socket to the machine.
To Next Page
Loading...
