arcelik Beko B13 - Step Nr. 14: Pump Control; Step Nr. 15: Jet Pump Control

B13 BETTER (B13 BEST APPEARANCE) WASHING MACHINE SERVICE HANDBOOK
94
10.15. Step nr. 14: Pump control
Explanation:
Motor rotating with 52 rpm in the previous step is stopped.
Pump is driven.
Furhermore, water is taken in by MAIN_WAS_VALVE and HOT_WATER_VALVE
concurrently for 5 sec. at the beginning of this step. Both valves are switched off at the end of
5 sec.
Indicators on the interface:
"Test" is displayed on the remining time indicator.
Condition to switch to the next step:
If the water level in the machine falls down to "Psafety - 15.0Hz" level, next step starts
automatically.
WARNING: Even if the “Start/Pause” button is pressed as long as water level has not
reached "Psafety - 15.0Hz", "Jet Pump" control step will not start.
Timeout: If “Start/Pause” button is not pressed in 2 minutes, "OFF" mode is started.
Switching to the next step:
“Start/pause” button is pressed.
NOTE : If "ON/OFF" button is pressed for 3 seconds, machine goes to "OFF" mode.
10.16. Step nr. 15: Jet Pump control
Explanation:
Pump is stopped. Jet System Pump
Motor is rotated 52 rpm clockwise.
Indicators on the interface:
"Test" is displayed on the remining time indicator.
Condition to switch to the next step:
-
Timeout: If “Start/Pause” button is not pressed in 2 minutes, "OFF" mode is started.
Switching to the next step:
“Start/pause” button is pressed.
NOTE : If "ON/OFF" button is pressed for 3 seconds, machine goes to "OFF" mode.