B13 BETTER (B13 BEST APPEARANCE) WASHING MACHINE SERVICE HANDBOOK
42
3. Take out the filters on the flat ends of the water intake hoses together with the gaskets and
clean thoroughly under running water.
4. Replace the seals and filters carefully and tighten their nuts by hand.
7.5. Draining remaining water and cleaning the pump filter
The filter system in your machine prevents solid items such as buttons, coins and fabric fibers
clogging the pump impeller during discharge of washing water. Thus, the water will be discharged
without any problem and the service life of the pump will extend.
If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned whenever it is
clogged or in every 3 months. Water must be drained off first to clean the pump filter.
In addition, prior to transporting the machine (e.g., when moving to another house) and in case of
freezing of the water, water may have to be drained completely.
WARNING:
Foreign substances left in the pump filter may damage your machine or may cause
noise problem.
WARNING:
If the product is not being used, the tap must be shut, mains pipe must be removed
and the water inside the machine must be drained against any likely freezing.
WARNING:
Close the tap to which the mains pipe of the product is connected after each use.
In order to clean the dirty filter and discharge the water
:
"1 Unplug the machine to cut off the supply power.
WARNING:
Temperature of the water inside the machine may rise up to 90 ºC. To avoid burning
risk, filter must be cleaned after the water in the machine cools down.
2. Open the filter cap.
Figure 7.4
3. Some of our products have emergency draining hose and some do not.
Follow the below procedures in order to drain water.
If the product has an emergency water draining hose, in order to drain the water:
To Next Page
Loading...
