B13 BETTER (B13 BEST APPEARANCE) WASHING MACHINE SERVICE HANDBOOK
41
Figure 7.2 Bellows cleaning
If the holes on the bellow shown in the figure is blocked, open the holes using a toothpick.
Foreign metal substances will cause rust stains in the drum. Clean the stains on the drum
surface by using cleaning agents for stainless steel. Never use steel wool or wire wool.
WARNING:
Never use sponge or scrub materials. These will damage the painted and plastic
surfaces.
7.3. Cleaning the body and control panel
Wipe the body of the machine with soapy water or non-corrosive mild gel detergents as necessary,
and dry with a soft cloth.
Use only a soft and damp cloth to clean the control panel.
7.4. Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the machine and also at the end
of each water intake hose where they are connected to the tap. These filters prevent foreign
substances and dirt in the water to enter the washing machine. Filters should be cleaned as they
do get dirty.
Figure 7.3
1. Close the taps.
2. Remove the nuts of the water intake hoses to access the filters on the water intake valves.
Clean them with an appropriate brush. If the filters are too dirty, remove them from their places
with a pliers and clean in this way.
To Next Page
Loading...
