B13 BETTER (B13 BEST APPEARANCE) WASHING MACHINE SERVICE HANDBOOK
89
NOTE : If "ON/OFF" button is pressed for 3 seconds, machine goes to "OFF" mode.
10.6. Step nr. 5: Motor counterclockwise washing control
Explanation:
Drum is rotated counterclockwise with a speed of 52 rpm.
Indicators on the interface:
"Instant speed" is displayed on the remining time indicator.
Condition to switch to the next step:
Timeout: If “Start/Pause” button is not pressed in 2 minutes, "OFF" mode is started.
Switching to the next step:
“Start / Pause” button is pressed.
NOTE : If "ON/OFF" button is pressed for 3 seconds, machine goes to "OFF" mode.
10.7. Step nr. 6: Machine spin speed (max. speed) Control
Explanation:
If the water level read in frequency is lower than "Psafety+15.0 Hz" (if the water level is 15
Hz higher than Psafety), pumping is made prior to performing this step, until water level is
dropped 15.0 Hz below "Psafety" level.
If the level is suitable during first entering into this step (if water level is below "Psafety+15.0
Hz" as level), spinning in MAX speed is performed without pumping.
Indicators on the interface:
If there is not any error, the aimed speed is shown in speed segments and the instantly
measured speed is displayed in the remaining time field.
Condition to switch to the next step:
Timeout: If “Start/Pause” button is not pressed in 2 minutes, "OFF" mode is started.
Switching to the next step:
“Start / Pause” button is pressed.
NOTE : If "ON/OFF" button is pressed for 3 seconds, machine goes to "OFF" mode.
10.8. Step nr. 7: Steam Valve Control (If there is no steam valve, this step will
be skipped.)
Explanation:
Steam valve is driven.
Water is taken from Steam Valve until the read water level frequency falls below
""Psafety+12.0 Hz" (until the water level increases by "Psafety+12.0 Hz"). Valve is switched
off once the water level is completed.
Indicators on the interface:
"Test" is displayed on the remining time indicator.
Condition to switch to the next step:
Timeout: If “Start/Pause” button is not pressed in 2 minutes, "OFF" mode is started.