B13 BETTER (B13 BEST APPEARANCE) WASHING MACHINE SERVICE HANDBOOK
15
5.4. Connecting to water supply
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1
MPa). It is necessary to have 10 – 80 liters of water flowing from the fully open tap in 1
minute to have your machine
run smoothly. Attach a pressure reducing valve if water
pressure is higher.
If you are going to use the double water-inlet product as a single (cold) water-inlet unit,
you must install the supplied stopper to the hot water valve before operating the product.
(Applies for the products supplied with a blind stopper group.)
WARNING:
Models with a single water inlet should not be connected to the hot water tap. In
such a case the laundry will get damaged or the product will switch to protection mode and
will not operate.
CAUTION: Do not use old or used water inlet hoses on the new product. It may cause
stains on your laundry.
Figure 5.5
WARNING:
Ensure that the cold and hot water connections are made correctly when
installing the product. Otherwise, your laundry will come out hot at the end of the washing
process and wear out.
1. Connect the special hoses
supplied with the product
to the water inlets on the
product. Red hose (left)
(max. 90 ºC) is for hot
water inlet, blue hose
(right) (max. 25 ºC) is for
cold water inlet.
To Next Page
Loading...
