B13 BETTER (B13 BEST APPEARANCE) WASHING MACHINE SERVICE HANDBOOK
88
Explanation:
Indicators on the interface:
Software version is shown in the remaining time field.
Condition to switch to the next step:
Timeout: If “Start/Pause” button is not pressed in 2 minutes, "OFF" mode is started.
Switching to the next step:
“Start/Pause” button is pressed.
NOTE : If "ON/OFF" button is pressed for 3 seconds, machine goes to "OFF" mode.
10.4. Step nr. 3: Indicator control
Explanation:
Indicators on the interface:
All LEDs flash. 1sec ON, 1sec OFF
Condition to switch to the next step:
Timeout: If “Start/Pause” button is not pressed in 2 minutes, "OFF" mode is started.
Switching to the next step:
Press "Start/Pause" button.
NOTE : If "ON/OFF" button is pressed for 3 seconds, machine goes to "OFF" mode.
10.5. Step nr. 4: Water level sensor / NTC / Mains voltage / Motor clockwise
control
Explanation:
Water Level Sensor control is perfromed. If there is water level sensor error, system goes to
the “Displaying of the errors occurred on the Test Mode” step which is the last step of “Test”
mode.
NTC control is performed. If there is error, System goes to the “Displaying of the errors
occurred on the Test Mode” step which is the last step of “Test” mode. Heater is not driven.
If there is not any error in Mains Voltage ADC inputs. If there is error, System goes to the
“Displaying of the errors occurred on the Test Mode” step which is the last step of “Test”
mode.
Drum is rotated clockwise with a speed of 52 rpm.
Indicators on the interface:
"Instant speed" is displayed on the remining time indicator.
Condition to switch to the next step:
Timeout: If “Start/Pause” button is not pressed in 2 minutes, "OFF" mode is started.
Switching to the next step:
“Start / Pause” button is pressed.
To Next Page
Loading...
