B13 BETTER (B13 BEST APPEARANCE) WASHING MACHINE SERVICE
HANDBOOK
46
1. Water intake in all programmes is carried out by the water counter. Whether or not
the water level drops below the levels determined in accordance with the steps is
checked by water level sensor. If the level has dropped, water will again be taken in
by the water counter.
2. Under the following conditions, water intake is performed by water level sensor, and
not by water counter.
If power is cut off during water intake,
If there is a failure in water counters or connections thereof, water is taken in by water
level sensor.
3. Top closure algorithm is applied at the beginning of programmes.
Figure 8.2 Top closure algorithm
4. Water intakes afterwards will be realized in accordance with the levels determined on
the basis of programmes. If the selected programme temperature is 60C or higher
than 60C, water intake will be performed vie hot water valve. Otherwise, water is
taken from the cold water valve.
5. Load amount in the machine is determined according to the number of valve
openings in this step.
If the machine is 8 kg, max. number of water intake in Cottons programme is limited
with 5.
TOP KAPAMA ALGORİTMASI
Ana yıkama adım başı mı?
6 saniye CV1'den
su al
Evet
1 saniye tahliye
2 saniye bekle
Su kesik testi
10 saniye bekle
END
Top closure algorithm will not be
applied under the following
conditions:
If previous programme was
canceled and a new programme
was started, top closure
algorithm will not be applied in
the newly selected programme.
Top closure algorithm will not be
run in autoprogramme.
TOP CLOSURE ALGORITHM
Is the main wash at the
beginning of the step?
Yes
No water test
Take water from
CV1 for 6 seconds
Wait for 2 seconds
Drain for 1 second
Wait for 10
seconds
END
To Next Page
Loading...
