Audi TT 2007 - Page 108

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove nut -3- and remove wiring harness bracket -2-.
– Remove starter mounting bolt -1- and starter.
– Disconnect electrical connector -1- on oil level thermal sensor
-G266- .
– Unclip bracket -2- for electrical wire to oil level thermal sensor
on subframe.
– Remove exhaust system bracket bolts -arrows-.
– Remove the bolts -2- and -3-.
– To avoid axle alignment, secure the subframe. Refer to ⇒
Suspension, Wheels, Steering; Rep. Gr. 40 ; Description and
Operation .
– Remove subframe. Refer to ⇒ Suspension, Wheels, Steering;
Rep. Gr. 40 ; Removal and Installation .
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
102 Rep. Gr.34 - Controls, Housing