Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove exhaust system bracket bolts -arrows-.
– Remove the bolts -2- and -3-.
Note
Ignore bolt -1-.
– To avoid axle alignment, secure the subframe. Refer to ⇒
Suspension, Wheels, Steering; Rep. Gr. 40 ; Description and
Operation .
– Remove subframe. Refer to ⇒ Suspension, Wheels, Steering;
Rep. Gr. 40 ; Removal and Installation .
– Remove right drive axle heat shield from bevel box -arrows-.
– Remove the right drive axle from the bevel box flange shaft.
– Raise the drive axle as far as possible and secure with a cable
tie.
Note
Ensure drive axle protective coating is not damaged.
– Remove the bolts -arrows- and remove the bevel box bracket.
Audi TT 2007 ➤
Manual Transmission - Edition 10.2009
120 Rep. Gr.34 - Controls, Housing
To Next Page
Loading...
