AudioCodes Mediant 800 - 54 Reporting DSP Utilization through SNMP MIB

CHAPTER54 Reporting DSP Utilization through SNMP MIB
Mediant 800 Gateway & E-SBC | User's Manual
54 Reporting DSP Utilization through SNMP MIB
You can obtain information on the percentage of DSP resources utilized by the device, through the
SNMP MIB table, acPMDSPUsage. You can also configure low and high DSP utilization
thresholds for this MIB, that if crossed, the SNMP trap event, acPer-
formanceMonitoringThresholdCrossing is sent by the device. For more information on this MIB,
refer to the SNMP Reference Guide.
- 993 -