AudioCodes Mediant 800 - Emergency Mode

CHAPTER39 CRP Configuration
Mediant 800 Gateway & E-SBC | User's Manual
Index
Source IP
Group /
Emergency
Request
Type
Destination
Type
Destination
IP Group
Destination
Address
Alternative
Route
Options
5 #1 [CRP
Users]
All IP Group #3 [CRP
Gateway]
- Alternative
Route
Ignore
Inputs
6 #2 [CRP
Proxy]
All IP Group #1 [CRP
Users]
- Route Row
7* #2 [CRP
Proxy]
All IP Group #3 [CRP
Gateway]
- Route Row
8 #3 [CRP
Gateway]
All IP Group #2 [CRP
Proxy]
- Route Row
9 #3 [CRP
Gateway]
All IP Group #1 [CRP
Users]
- Alternative
Route
Ignore
Inputs
The routing rule at Index 7 appears only if the CRPGatewayFallback parameter is
enabled (see Configuring PSTN Fallback). This routing rule is used if the device can't
find a matching destination user for IP Group 1 (User-type IP Group) in its registration
database. If the CRPGatewayFallback parameter is disabled and no matching user is
find, the device rejects the call.
Emergency Mode
The pre-configured IP-to-IP routing rules for the Emergency CRP call survivability mode are shown
in the table below:
Table 39-3: Pre-Configured IP-to-IP Routing Rules for Emergency Mode
Mode
Inde-
x
Source
IP Group
/
Emer-
gency
Request
Type
Destin-
ation
Type
Destin-
ation IP
Group ID
Destin-
ation
Address
Altern-
ative
Route
Options
Always
Emergen
cy
1 Any OPTIO
NS
Dest
Address
- Internal Route
Row
4 #1 [CRP
Users]
All IP Group #1 [CRP
Users]
Route
Row
5 #1 [CRP
Users]
All IP Group #3 [CRP
Gateway]
Route
Row
9 #3 [CRP
Gateway]
All IP Group #1 [CRP
Users]
Route
Row
- 876 -