AudioCodes Mediant 800 - CAS Parameters

CHAPTER72 Configuration Parameters Reference
Mediant 800 Gateway & E-SBC | User's Manual
Parameter Description
■ [0] Disable (default)
■ [1] Enable
Note:
■ For the parameter to take effect, a device
reset is required.
■ The parameter is applicable only when the
TDMBusPSTNAutoClockEnable
parameter is set to 1.
CAS Parameters
The Common Channel Associated (CAS) parameters are described in the table below.
CAS is applicable only to ISDN PRI interfaces.
Table 72-54:CAS Parameters
Parameter Description
[CASOrientedBoard] Enables DSP resource allocation for
CAS.
■ [0] = (Default) Disable.
■ [1] = Enable.
Note:
■ For the parameter to take effect, a
device reset is required.
■ Enable the parameter before
configuring CAS.
'CAS Transport Type'
cas-transport-type
[CASTransportType]
Determines the ABCD signaling transport
type over IP.
■ [0] CAS Events Only = (Default)
Disable CAS relay.
■ [1] CAS RFC2833 Relay = Enable
CAS relay mode using RFC 2833.
The CAS relay mode can be used with the
TDM tunneling feature to enable tunneling
over IP for both voice and CAS signaling
bearers.
[CASAddressingDelimiters] Enables the addition of delimiters to the
received address or received ANI digits
string.
■ [0] = (default) Disable. The address
and ANI strings remain without
delimiters.
- 1340 -